PVCu Solvent Cement Fittings | Connection Guide

PVC-U Solvent Cement is used for filling gaps. The cement works by softening the inside of the fitting and the outside of the pipe to form a joint chemically.
 

How to use PVC-U Solvent Cement

1. Cut the pipe end square

2. Remove burrs and clean swarf. A chamfer must be filed approximately 3mm x 45° to prevent the layer of cement being scraped away as the pipe is pushed into the fitting.

3. Use a pen to mark the pipe at the distance which will penetrate the socket to the stop.

4. Thoroughly clean the pipe and fitting surfaces with MEK cleaner on a clean cloth.

5. Stir the PVC-u cement thoroughly.

6. Use a clean brush approximately half as wide as the pipe to be jointed. Apply cement to the pipe and fittings using longitudinal strokes coating the pipe thicker than the fitting. The prepared areas should be completely covered with cement.

7. Apply the cement quickly to enable assemble without excessive force being necessary.

8. Immediate after apply cement push pipe fully into the fitting without rotating. Hold the pipe and fitting for up to a minute to ensure fitting does not slide off the pipe. If working in cold conditions ensure the joints are free from frost and moisture and allowing extra curing time.

9. Wipe off excess cement from both sides of the joint using a clean cloth.

10. Replace lids onto tins and clean brush with MEK cleaner.

Precautionary Points to Consideration

• The jointing area must be well ventilated
• Wear gloves when applying cement and cleaner
• Always use clean brushes
• Ensure cement is used is used prior to its expiry date
• Always use clean lint-free cloth or absorbent paper
• Never dilute PVC-u solvent cement
• Do not allow a naked flame or smoking in the jointing area
• Always replace lids on tins when not in use
• Ensure jointing surfaces are dry in wet weather